Taurus L4-153 2.5L HSC (1986)
Wiper Arm: All Technical Service Bulletins
Wiper/Washer Arm - Contacts `A' Pillar
Article No. 86-9-4
WIPER/WASHER ARM CONTACTS "A" PILLAR - UNITS BUILT PRIOR TO 2/4/86
FORD 1986 TAURUS
LINCOLN-MERCURY 1986 SABLE
If the windshield wiper arm assembly repeatedly "slaps" the "A" pillar at the driver's side can be corrected simply by removing the driver's side wiper
arm and blade assembly and re-indexing it using the instructions listed below.
1.
Turn on the wiper switch, allow the motor to move the pivot shafts three or four cycles, then turn off the switch. This procedure will place the
pivot shafts in the PARK position.
2.
Remove the (driver's side) wiper arm and blade assembly by first applying downward pressure on the wiper arm head while holding the wiper arm.
Then lift the arm to the highest position and using finger pressure only, grasp the latch tab and slide the latch out from under the arm head.
